Depends on the finish you want to end up with. Most painters will block out or wet sand the primer to a nice smooth surface with increasing # sand paper (higher # = finer grit). Most guys will stop somewhere around 800 b/c you still want to give the paint something to adhere to. This is if you are wanting the slickest finish possible. If you are just wanting a matte finish where smoothness isn't totally important you can just scuff and go.
Save Share
Reply Quote
cbchess
·Map MakerJoined Dec 20, 2003
·1,243 Posts
#3 · Sep 7, 2011
- Only show this user
yes!
minimum 220
Richmond, VA
Ra-MORE mtb club
Save Share
Reply Quote
f3rg
·pedal pusherJoined Aug 29, 2007
·2,712 Posts
Discussion Starter · #4 · Sep 7, 2011
- Only show this user
Thanks, guys. I already hit it with 400 grit, and I'll do 800 next. Its previous finish was matte and I couldn't stand it, so I want a very smooth finish this time around.
Save Share
Reply Quote
GGodfather1138
·Registered
Joined Aug 13, 2011
·57 Posts
#5 · Sep 7, 2011
- Only show this user
cbchess said: yes! Click to expand...
Which would be the scuff and go method
minimum 220
jgerhardt
·Bike FreakJoined Aug 31, 2009
·324 Posts
#9 · Sep 8, 2011
- Only show this user
Many automotive shops only go up 320 grit wet sanded.
My bikes [Fe][C]ycles
Save Share
Reply Quote
Ddbohemian
·Registered
Joined Mar 25, 2007
·725 Posts
#10 · Sep 8, 2011
- Only show this user
Doug (also flyinfrog) are of course correct. Doug has been a professional painter for 30+ years? Or something like that amount (Hi Doug)
Automotive shops may only go to 320 because of speed. Time is money of course. That is not necessarily what does the best job. If using metallics or pearls you must sand to a finer grit (600 wet is standard) to reduce sand scratches that can be seen after clearing.
I use dry papers that are graded to a particular coursness. Realize that 600 wet would typically be something like 800 dry and that a lot of papers are now micron graded so there is not an absolute direct correlation.
Good luck, lets see pictures after you are done.
All the best,
Dave Bohm
Bohemian Bicycles
//www.framebuildingschool.com
//www.carbonframebuildingschool.com
Save Share
Reply Quote
Ddeepat
·Registered
Joined Sep 9, 2011
·28 Posts
#11 · Sep 9, 2011
- Only show this user
flynfrog said: I wouldn't go much past 600 you will start to lose to much bite on your paint. Check with the data sheet for the paint you are using most are 400-600. The color will make a difference to metallics will settle into any sanding scratch you missed. Click to expand...
I agree...
Save Share
Reply Quote
CCheakas
·Registered
Joined Feb 2, 2006
·5 Posts
#12 · Sep 12, 2011
- Only show this user
I usually do only minimal sanding on primer, pretty much just knocking down any rough spots. Then I use the first base coats as guide coats and sand them flat. That way there's less of a chance of sanding though the primer and having to respray primer. It's a lot more time consuming and uses more paint, but I think the results are worth it.Do you need to sand after priming?
How many coats of primer should I use on metal?