Hoover powerdash pet carpet cleaner not spraying water

Índice Show

Clean the water collection tank & filters
Why is my carpet cleaner not releasing water?
How do you fix a carpet cleaner that won't spray?

Clean the water collection tank & filters

To keep your cleaner in good working order and deliver the best suction power we recommend that you wash out the collection tank and foam filter after every use and leave to dry thoroughly before re- fitting to the cleaner.

Also keep the pre motor filter clean shown here. Lift the tank off and it is the rectangular filter found in the base of the cleaner.

Small rectangular filter in the centre of the picture

Always disconnect your appliance from the mains before you start examining it!

This solution applies to the following models:

Answer #1: Posted by Odin on June 14th, 2021 11:40 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 40,836,680

1,100
points

There is a release button where the cleaner holds the water tank. The button is on the same side as the handle.

If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/hoover.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Answer #2: Posted by SonuKumar on June 14th, 2021 10:03 PM

SonuKumar

Member since:
May 9th, 2021

Points: 12,254,480

100
points

There is a release button where the cleaner holds the water tank. The button is on the same side as the handle.

How do you prime a Hoover carpet cleaner?

You "prime the pump" by attaching the tool to the hose and turning the carpet clearer to ON. Then put the tool on a hard surface or against your hand to block the suction. It may take up to 15 seconds to remove all the air. Once this is done, squeeze the trigger on the machine and begin to clean.

Why is my Hoover carpet cleaner not spraying water?

Air Is Stuck in Pump or Hose

If the cleaner is still not spraying despite the water and detergent tanks being full, there may be a bubble of air stuck in the pump or the hose. To fix this, you need to turn the cleaner on and lower the hose down to the floor.

How good is a Hoover PowerDash Pet Carpet Cleaner?

The Hoover PowerDash Pet Compact Carpet Cleaner is a solid investment for pet owners. The lightweight machine doesn't have the extra features higher-end carpet cleaners have, but it's affordable and powerful and handled most messes left behind by our furry friends.

https://www.justanswer.com/uk-appliance/bmfxc-remover-handle-pole-hoover-power-dash.html

https://www.youtube.com/watch?v=9R08hULZB1w

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Product Manual - Page 1

Distributed by, Royal Appliance Mfg. Co. USER MANUAL POWERDASHTM CARPET CLEANER IMPORTANT: Read all instructions carefully before assembly and use only. All Rights Reserved. If used Commercially warranty is intended for Household use . This product is VOID. ©2020 Techtronic Floor Care Technology Limited. All Rights Reserved. 964A00230-R1 Charlotte, NC 28262.

Product Manual - Page 2

Register your carpet cleaner by: Visiting Hoover.com or Hoover.ca Calling 1-800-944-9200 IT'S GUARANTEED. Make it official. See warranty for up to Hoover® ownership. Get cleaning confidence for complete details. 2 Welcome to 1 year with the Hoover® limited warranty.

Product Manual - Page 3

Table of Contents Safety Instructions 4 Product Guide 6 How to Assemble 7 Before You Begin Cleaning 7 Getting Started 8 Maintenance 10 Troubleshooting 14 Warranty ...15 Français...16 Español...31 Carton Contents Carpet Cleaner Upper Handle Upper Handle Pole Clean Water Tank Dirty Water Tank PowerSpin Brush Roll Sample Bottle of Cleaning Solution 3

Product Manual - Page 4

..., and do not allow power nozzle with this user's manual. Close supervision is not working as a handle, close a door on cord.... IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE USING THIS PRODUCT. Use only Hoover recommended attachments. • To Reduce the Risk of time, as a toy. Do not expose machine...

Product Manual - Page 5

... is not available (Fig. 2). If it will not fit the outlet, have a proper outlet installed by a qualified electrician. This appliance is for electric current to a 2-pole receptacle (E) if a properly grounded outlet is used only until a properly grounded outlet (B) can result in the risk of electric shock. The plug must be used...

Product Manual - Page 6

... Tank 2 4. Filter (Under Dirty Water Tank) 6. Upper Handle 10. PowerSpin Brush 9. On/Off Pedal 4 12. Handle Release Pedal 5 6 9 10 12 6 7 11 13 8 Dirty Water Tank 5. Quick Pour Spout 3 7. Removable Nozzle 8. Upper Handle Pole 11. Product Guide 1. Dirty Water Tank Handle Release (NOT A CARRY HANDLE!) 13. Cord Wrap 3. Water/Solution Trigger 1 2.

Product Manual - Page 7

..., hidden area. Test for "solvent/dry" or "wet" clean). Use your Hoover carpet cleaner only if upholstery fabric is marked with a white paper towel. NOTE: To prevent staining, use . 1 Insert the Upper Handle into the Upper Handle Pole until you hear a "CLICK". 2 Insert the upper Handle Pole into the base until you hear a "CLICK". 3 Slide the Clean Water...

Product Manual - Page 8

... personal injury or damage, and to prevent the cleaner from the back of stairs or on stairs. Getting Started With Your PowerDash™ Carpet Cleaner Fill the Clean Water Tank 1 Remove the Clean Water Tank from falling, always place cleaner at bottom of the unit. 3 Add Hoover® cleaning solution to the Water fill line...

Product Manual - Page 9

...higher pitched and there is visible passing through the nozzle. • Hoover recommends rinsing carpet with water only. For Best Performance • For full suction,...and may puddle. Getting Started With Your PowerDash™ Carpet Cleaner How to Clean Carpets with your PowerDash™: 1 Plug power cord into electrical outlet. 2 Step on ON/OFF...Step on the Handle Release Pedal to turn ON.

Product Manual - Page 10

... center or call customer service at 1 (800) 944-9200 prior to continuing use. Turn power switch off and unplug from the back of personal injury - Maintenance How to Empty and Clean your Tanks ...Dirty Water Tank 1 Turn the cleaner off and unplug before cleaning or servicing. 4 Open Quick Pour Spout and empty. 5 Replace ...

Product Manual - Page 12

...tool to comb through the bristles to remove 6 screws. Visit Hoover.com to dry. *Tool may not be included in front of wheel BRUSHROLL & COVER CLEANER 1 Use comb side of tool to get inside nozzle area ...to remove any excess debris or hair. Arrows show location of cleaner. 2 To remove belt covers, use Philips screwdriver to remove debris & hair. 3 Remove belt...

Product Manual - Page 13

... caps are in their correct orientation. 5 Replace belt covers and secure by replacing all 6 screws. *in front of wheel STORAGE: Allow brushes and underside of carpet cleaner to air dry thoroughly before storing carpet cleaner on a carpeted or wood surface. 13

Product Manual - Page 14

...home 3. Clogged Filter 6. Ensure trigger is being pulled Brushes won 't run 1. Fuse in cleaner blown 4. Take to Clean" page 11 5. Plug unit in dispense position 2. Dirty Water ...any questions or, visit Hoover.com or connect with us: Twitter: @HooverUSA Facebook: facebook.com/hoover Do not return to Clean" page 10 4. See back of the carpet washer is located on ...

Product Manual - Page 15

... operation, performance, or durability. WARRANTY LIMITED WARRANTY FOR HOOVER® PRODUCT ONE YEAR LIMITED WARRANTY (DOMESTIC USE)...in the event that the issue you for carpet and spot cleaners), parts, and accessories. Please have other ..., belts, filters, brush rolls, blower fans, blower and vacuum tubes, and vacuum bags and straps. any other rights, which are not reasonably...

Product Manual - Page 47

Find us on: Hoover.com youtube.com/hoover facebook.com/hoover twitter.com/hooverusa

Product Manual - Page 48

... motion without holding the trigger. Add Hoover® Solution to recline handle and power on. Use pedals to next line.... Slide Clean Water Tank into the base of the unit. Remove Tank, twist off cap and ll with warm water to ll line. Replace cap and reinstall tank. To Clean: Slowly push forward then backward while holding the trigger. Insert Pole...

Why is my carpet cleaner not releasing water?

If your machine is still not spraying, check to make sure the clean tank has water and/or the water & formula mixture in the tank. If your tank is empty, this could be the reason your machine is not spraying. You will need to fill your clean tank again. Reset the tank and ensure it sits snug on the machine.